Or the router, in another state, and the person with access to the closet/server room knows how to push a few buttons at best.

That happens once… and you get misconfigophobia for life.

It may be easier to supply DC power directly to the soldering joints (at the right values after the converter) or even replacing that one component as using the jack itself.

A bunch of tiny lightbulbs that use twisted light and quantum mechanics to turn on or off.

And if you want to tank it without overtly tanking it.

“We will need to establish a review and governance board to establish standard data structures and reporting that can be used to drive the initiative.

It will need to be cross team and cross specialty so we should start by establishing a group to identify those people so we can proceed”

A year later and you’ll be lucky if they’ve even picked out who can be part of the review process let alone agree on some convention and adjusting their tooling and processes to make that work.

Psych

They’re sure you will, or some will, but the number of customers they lose will be offset by the revenue gained.

Since that’s the only metric they really care about at the end of the day it makes “sense” to them to do it.

If I recall correctly it’s important to be running ECC memory right?

Otherwise corrupter bites/data can cause file system issues or loss.

I see a lot of good answers here but let’s try it from another angle.

How do we get randomness from a function or formula?

For starters let’s setup a few simple rules.

Every time our random function is called we’ll

• Take the last output from a variable we call LAST_RESULT
• If there’s no value in LAST_RESULT we’ll assume the value is 1
• We run a set of calculations storing the value in a variable we call X
• We store the result of these calculations in LAST_RESULT
• We return this new “random” number.

So let’s call it.

> Random()
Since LAST_RESULT is undefined SET LAST_RESULT to the value of 1
Set X to the result of this calculation 
   (LAST_RESULT+1) * 3

X is now 6

Set X to the result of this calculation
   (X + 7) / 2

X is now 7

Set X to the result of this calculation (rounding to the nearest whole number)
   X/LAST_RESULT

X is now 7

Set LAST_RESULT to the value of X

LAST_RESULT is now 7

Return the value of X as the result 

Result is 7

Ok. So let’s call it again

 > Random()
Set X to the result of this calculation 
   (LAST_RESULT+1) * 3

X is now 24

Set X to the result of this calculation
   (X + 7) / 2

X is now 16

Set X to the result of this calculation (rounding to the nearest whole number)
   X/LAST_RESULT

X is now 2

Set LAST_RESULT to the value of X

LAST_RESULT is now 2

Return the value of X as the result

Result is 2

And if we call it again we get seemingly random results

Random() Result is 4

Random() Result is 3

But the next time you run it you’ll get the same results in the same order. 7, then 2 then 4 then 3

So what you need is something to “seed” the random number calculation.

Something like

SetRandomSeed Set LAST_RESULT to the current second of the day

Then when you call Random after this it starts with that as the prior results and gives seemingly random results.

Of course my calculations are rough and probably fail/repeat after so many calls but it gives you an idea of how this works.

So the trick is to get noise for the seed. That could be the number of non leap seconds since 00:00:00 UTC on Thursday, 1 January 1970 (Unix epoch)

Or the temperature reading of a CPU chip.

Maybe it’s the ratio of red vs yellow from a camera feed looking at lava lamps.

Or the current users average typing speed.

An additional note. Many of those would not be “cryptographically” secure for encryption because they can easily be determined by a third party. We all experience the same “Unix epoch” within a few milliseconds if our system clocks are properly set for example. Or monitored from afar and reproduced (hacked webcam shows they had just typed the following letters in the previous 27 seconds that we know the “algorithm” uses, etc.

I’m looking forward to it with the family. I really enjoyed the audiobooks one week. Checked it out as a casual read after a heavy book but it’s was, like you mention, heartfelt and sweet.

If a person is at the intro/intermediate level that advice may be sound enough. Since they’re less likely to apply proper rules to include those ranges of IP’s etc.

Assuming it’s advising disabling it at the router/switch level and not just a per device level.

Better would be to explain: Disable this until you’re familiar with the following concepts (see cited books/material for more info)

Rise… and Shine… for todayyyy… the skies are… clear

“HL3: Estonian Shores” confirmed

G-man: Hello. Misterrrr Newsman…

Anchor: Um, we’ve talked about this. You can call me Frank.

G-man: No…. I’ll be Frank… with you… our mutual employerrr is not very… satisfied… with yourrr…. performance

It’s a link to Amazon digital product. Specifically Rick Astley “The Best Of Me” album with Never Gonna Give You Up.

The “description” of the product doesn’t matter as long as the product code is the same.

https://www.amazon.com/Whatever-You-Want-Here/dp/B07X66DCLM

A trick I saw used a couple times on Reddit a few years back

It was a webcomic that took itself too seriously and it was so panned that the mockery of it reverberates even today.

May not be for everybody but it was definitely something to experience at the time. Sometimes the internet has these weird flashes of communal focus (which can be both good and bad) but either way these allusions are all of us nudging each others side with our elbow and winking at the same inside joke when we see it.

It’s not funny on its own. It’s funny because it’s an inside joke we all share.

The community mockery and allusion to the original is what makes the entire phenomenon.

Kind of like this pop up book on Amazon is a “isthisloss” in 3d.

https://www.amazon.com/Is-This-Art---4-Panel-Popup/dp/B07X66DCLM

It’s clever because it’s unexpected even if we all know what it is

Crazy Tuesday… the day we eat at Crazy Joes Taco Palace.

And that’s why Belters shouldn’t cross into gate space while watching a show. Too risky to have the ship go Dutchman because the entities can sense your embarrassment.

Does make it easier to isolate vocals I guess