This is done intentionally, and repeats further throughout the installation. The main reason is it prevents long runs of grout lines. The installation will be stronger, and there’s no need for an expansion joint. Additionally, it’s harder to see if the grout joint shifts one direction or the other over a long run.

I don’t think it need to be done every fifth tile though- that’s a design choice by the installer.

Is there any way you can take a picture of the engine from directly above it?

It should be more towards the passenger side, maybe more forward then center. It may not say oil, but rather 5w-30 or something like that.

Hey there. I had the Chevy version of this truck once upon a time. The location depends on what engine you have:

If you have a 4-cylinder, cap should be near the center on top of the engine. If it’s the 4.3L V6 the cap will be off to one side, but still on top. I think we’re looking at the v6 here.

Look for a black or yellow cap, it should say OIL.

This did it! Thank you! I actually found this page and did the first half, not realizing there was more. I’m not confident I installed the exact correct driver, but I have dual screens in the proper resolution. This should get me by while I troubleshoot everything else.

Thanks again!

Wow. That looks fucking terrible.

What’s crazy is that I wasn’t familiar with erythritol, and searched to see what had it as an ingredient. The entire first page of results were almost all the same AI generated cream touting the benefits of erythritol, like they were trying to sell me on it. And no specific foods were listed that had it as an ingredient.

There were a lot of things like “consider the delicious possibilities that erythritol can bring to your table.” Someone is trying to sell it that hard, then that alone tells me I should probably avoid it.

Nine sili nebesniye, Alexander Sheremetiev.

That looks better than my view, unfortunately. Total cloud cover rolled in 10 minutes before totality.