I’m pretty sure that’s only a theory and not something that’s ever actually been confirmed. That said people on /r/datahoarder have raved about those drives for 5+ years at this point, and so far all 6 of my drives have been going strong after 6 years of constant abuse.

What standby mode does your laptop use? Classic S3 standby, or S0 standby like most modern laptops are forced into?

Just know that higher RPM doesn’t necessarily mean higher noise. In my experience Helium filled drives can be pretty quiet, and basically all really high capacity drives are helium filled.

I have an arm of shucked WD drives and while I can hear them from time to time, they’re not bad. Also your case makes a huge difference. Make sure the drives are on rubber isolators, and what they’re mounted on can’t vibrate to make any noise. The only noise I hear from these drives is when they first spin up after being idled.

Is 5640 RPM acceptable? WD reds are all about 5400rpm and are basically the gold standard for NAS HDDs.

You can shuck them out of WD easy store drives sold at best buy. They’re white label drives from WD, but they’re all based on the red/red pro drives.

Collections is exactly what I’d love to see added to lemmy. Especially if the collections has the ability to filter out posts cross posed to different communities.

That’s not necessarily what a “smart” device is.

Did you expect a doorbell with a camera built into it to not be “smart”?

Odds are your Linux install overwrote OCLP. You’d need to install OCLP again and configure it to boot from either Mac OS or your Linux install.

And with GPT partition you can have 128 partitions so ~120 different OSes easily on a single drive.

OP is using OpenCore Legacy Patcher to run an newer OS on an unsupported machine. The option boot menu won’t work, they’d need to get back to the OCLP menu to boot Mac OS.

Something along the lines of this

Supposedly easybcd supports efi now so you should be able to use that to do all the config.

Windows has a lovely “feature” where it installs the bootloader on a secondary drive if there’s one connected. It doesn’t install it on drive 1 and drive 2, just drive 2. I always disconnect all secondary drives before installing windows for this very reason.

That said you can configure the windows bootloader to recognize your Linux (or grub) and just use that to manage booting two OSes and it’s less likely to not destroy things.

Ya know, I wish I could at least say something about being european and using commas instead of periods for decimal points, but I can’t even say that. Still 6MB fully installed is nothing these days.

Does the size of a 6kb program really make that much of a difference?

Side note: If I’m reading this right (ignoring dependencies) sudo is 6kb while doas is 14kb.

Modern gaming laptops with Advanced Optimus are switching back to a mux for everything.

They’re still some of the best machines out there. Every other machine has gotten shittier at an even more rapid pace.

I liked the server I set up the other day. 512 gigs of ram, 1 gig swap.

We’re using maybe 100gigs currently.

Mac OS has has this nailed down basically perfectly for over 10 years now, even windows has been great in the last 5+ years. Not having scaling done right in the age of 4k displays being cheap is a sin.

(dying at 40% battery, randomly switching off and other similar things). I’m on my third replacement battery, so either I’m really unlucky or there’s something fishy going on

Not unlucky, they’re just garbage 3rd party batteries, and no official 1st party batteries.

Is your battery dead dead? It should work just fine with a 3rd party battery, I’ve never had any machines give me problems with 3rd party ones. It’s only when the battery is below 5% state of charge that it will throttle like that.

1 gbit because google fiber is 1gbit but I typically get 1.2 because they overprovision it so much.